You need to use the I1 command to invert the signal, refer to my first post on probe setting configuration.
Posts made by Modtcass
-
RE: Z probing in the wrong direction with inductive probe.posted in Tuning and tweaking
-
RE: Ezabl and deployprobe.g and retractprobe.gposted in General Discussion
Search my posts and it shows my config for the EZABL.
-
RE: Creality Ender 5 Configurationposted in Firmware installation
I have my the Duet Wifi CR-10S setup with EZABL and Titan Aero, I can share my configs with you if that will help you get things going. You'll have to adjust your steps and figure out the proper config for your probe.
-
RE: EZABL z-probe wiring and configurationposted in Duet Hardware and wiring
Hi I have tried your recommended steps with no success, can you copy and paste the line of code from your config.g file to verify that I am understanding your instructions ?
Update
I was able to configure it and run auto bed configuration. This is specific to my Titan Aero Extruder, please set your offsets accordingly.
