@phaedrux I also put in the g code that I disable those drivers but the error continues

@phaedrux yes, I changed it and connected everything, but it gives me that error and it shows the temperature in bed and hotend in 2000

Hola a todos tengo el siguiente problema, tuve un corto circuito que me daño mi mother board la cambie , pero cuando inicio la maquina me marca temperatura de cama y de extrusor altas, en el análisis me indica lo siguiente:

23/5/2022, 12:27:20: M122: === Diagnostics ===
RepRapFirmware for Duet 2 WiFi/Ethernet version 2.03RC3 running on Duet WiFi 1.02 or later + DueX5
Board ID: 0JD0M-9P6M2-NW4SD-6JKF4-3SJ6N-TBQVK
Used output buffers: 3 of 24 (6 max)
=== RTOS ===
Static ram: 25680
Dynamic ram: 94136 of which 416 recycled
Exception stack ram used: 320
Never used ram: 10520
Tasks: NETWORK(ready,784) HEAT(blocked,1236) DUEX(suspended,156) MAIN(running,3764) IDLE(ready,160)
Owned mutexes:
=== Platform ===
Last reset 00:00:57 ago, cause: power up
Last software reset time unknown, reason: User, spinning module GCodes, available RAM 10572 bytes (slot 3)
Software reset code 0x0003 HFSR 0x00000000 CFSR 0x00000000 ICSR 0x0441f000 BFAR 0xe000ed38 SP 0xffffffff Task 0x4e49414d
Error status: 0
Free file entries: 10
SD card 0 detected, interface speed: 20.0MBytes/sec
SD card longest block write time: 0.0ms, max retries 0
MCU temperature: min 31.7, current 35.4, max 35.6
Supply voltage: min 23.9, current 24.1, max 24.4, under voltage events: 0, over voltage events: 0, power good: yes
Driver 0: standstill, SG min/max not available
Driver 1: standstill, SG min/max not available
Driver 2: temperature-shutdown! short-to-ground standstill, SG min/max not available
Driver 3: standstill, SG min/max not available
Driver 4: temperature-shutdown! short-to-ground standstill, SG min/max not available
Driver 5: standstill, SG min/max not available
Driver 6: standstill, SG min/max not available
Driver 7: standstill, SG min/max not available
Driver 8: standstill, SG min/max not available
Driver 9: temperature-shutdown! short-to-ground standstill, SG min/max not available
Date/time: 2022-05-23 12:27:19
Cache data hit count 204368571
Slowest loop: 3.83ms; fastest: 0.07ms
I2C nak errors 0, send timeouts 0, receive timeouts 0, finishTimeouts 0, resets 0

Por lo que entiendo hay un corto en 3 drivers pero no ubico cuales son o a que estan conectados, me pueden ayudar a identificar correctamente la falla y solucionarla