@phaedrux Hi, I just removed the M24 from the end of the filament-error file and now it seems to be working properly. I ran a quick test print, caused a filament error and I was able to click "OK" to remove the error message popup, retract/unload the filament from the hotend, load new filament and resume printing.

Thanks so much for your help, it is very much appreciated.

@phaedrux Hi, your updated filament-error file works, but the problem is when the runout error message pops up, I cant load/unload filament and if I click on "OK" to get the message to go away, the printer immediately starts printing again without filament.

@phaedrux Hi, I updated my firmware as advised and now it reads as:

RepRapFirmware for Duet 3 Mini 5+ version 3.4.1 (2022-06-01 21:06:56) running on Duet 3 Mini5plus WiFi (standalone mode).

I ran a test print and caused a filament runout, the filament error message popped up, but the print didn't pause, it moved up and away from the print as it should, but then it started continue the print again in mid-air.

As for the filament-error.g file I didn't create it myself, I found it online. And yes, the filament error pop up message comes up on a runout.

@phaedrux Hi, I just ran a test, after the runout sensor paused the print I replaced the filament, but when I click "Resume Print" in the Job Control tab of DWC and nothing happens, the status is stuck as "Pausing" and I can't resume or cancel the print using either of the buttons in DWC

@phaedrux Hi, I'm using Firmware: RepRapFirmware for Duet 3 Mini 5+ 3.3 (2021-06-15).

I included my config, resurrect, filament-error, etc. files in my first post.
I'm not canceling anything, if I'm printing and the filament runs out, the machine pauses and gives me the "no filament" error message, then if I add a new spool of filament and click "Resume", I get the error message from my first post.

I'm sorry if that doesn't answer your question as I'm quite new to the whole RepRap Firmware/Duet system.

Hi, I have a Duet 3 Mini 5+ (running in standalone mode) with a Duet Magnetic Filament Monitor and I'm having trouble with restarting/resuming a print after a filament run-out.
The MFM successfully recognizes that the filament has run out and successfully pauses the print, however when I try to resume the print using M916 I get this error:

M98 P"0:/macros/Resume Print"
Error: in file macro line 30 column 12: M486: non-empty string expected
Error: in file macro line 31 column 62: M486: string too long
Error: Cannot set file to print, because a file is already being printed".

I've tried editing the resurrect.g file (removing the offending line/s), but nothing seems to work and I have to end up cancelling the print and starting over.
Any help would be very much appreciated.
Thank you.

config.g
resurrect-prologue.g
resurrect.g
resume.g
pause.g
filament-error.g