Best posts made by megaloduet

@droftarts do you have an advice in regards to the topic main problem ?

@phaedrux rotating the buildplate 90° has a slight improvement.
Will test another buildplate tomorrow and also clean both.

Shouldn't the meshbed leveling be capable of compensating the slight tilt? As done by the original Prusa ?

Have ordered springs and knobs to adjust the bed will also try this (I am afraid I can't use it because of narrow space between Y carriage an frame)

PID is tuned, this one I ruled out already.

Will report the progress tomorrow with both buildplates cleaned. If both show the same artifacts I think at least we can rule out the buildplate.

Next guess would be move the print around on the buildplate, maybe de magnets in the bed interfer with the hotend and push it down while printing over magnets ? Does this sound reasonable to test?