Topics created by massimilianoconti

I know thanks does not respond well the command compared to before now they are both activated simultaneously. there is something wrong. if I go from the dual panel it works for example but we will see thanks. I did not quite understand if the developer of the firmware is only Mr. Dozuki or beyond people.

@massimilianoconti yes

then your code was put first at the beginning then at the second attempt at the end of the macro. the home I ran after the printing had started so the machine was busy. thanks for the help

I'm still testing, for now it seems to me that panel two responds well. I created a new cable to connect duet 3 to I 0.0 to panel two. I reserve the right to update the outcome

Firmware 3.4 beta 7+7 solved the heater problem when starting a new print. the heater is fine part good also the bl touch seems to be fine. I do further tests and communicate news

ok then it's a firmware flaw

@TLAS nope. Wait it out for it to complete for reset and start again.
Longest tuning cycle I heard of was 12 hours and I don't think that completed either

hi should be fixed I switched to version 3.4 beta 3, seems not to do the problem anymore

motherboard duet wifi vers. 1.04

Board: Duet WiFi 1.02 or later
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 2.05 (2019-12-13b1)
Duet WiFi Server Version: 1.23

Negative reading on a diode test, and fans that dont work when they should. I think you need an excorcist, or maybe some pictures showing measurement and meter.

hi i think i solved it. I replaced the 24volt power supply and by testing I see that it doesn't create any more problems. the cause was something inside the power supply that at the time of the shutdown created a power return ... thank you very much for the help. the contact returns again for the simplify 3d speech and if I can then I want to create a help guide.