Best posts made by Martin1454

@zapta said in Pressure Advance: Discussion for Future Development:

NANANANA BATMAN!

I think it is amazing that you have installed an Duet wifi in a printer that cost almost the same as the duet
Looking foward to see then end result.

Biggest limitation? My imagination and understanding of the Gcode commands -

Other than that:
Missing stealth chop on the duet wifi, but spready cycle is okay -
12V fans on a 24V setup is only possible with external hardware (duex5 or an regulator)

For a small retrofit, I would go for the Duet Maestro, unless the print is complex (multiple extruder, multiple motors for auto leveling Z, etc.)

I use the paneldue, but 90% of my work is done through the web interface.

Finally to the point where im satisfied.

Biggeste change was changing to BL touch - After I got my hands on an thermal/IR camera, I could see that the bed was like a mirror for the camera, so that's why the IR probe didn't work good enough

That is beautiful! looking foward to see print quality if it is as pretty as the printer

@plasticmetal said in Duet Wifi limitations - what are your experiences?:

@martin1454 said in Duet Wifi limitations - what are your experiences?:

12V fans on a 24V setup is only possible with external hardware (duex5 or an regulator)

Just to clarify, the external hardware is simply to supply the 12V. It can be a $3 buck regulator from eBay or Amazon. A wiring example is here.

Yup - A small buck converter is enough - or if it is a small low power fan like the 30mm E3D, a linear 7812 is also fine.

rectilinear infill? try grid instead

Hi, Im looking to rebuild my 3d printer in the near future, and I will need a few extra connectors for the steppers and the output channels.

I can see the connectors are:

2 way shell VH396-02H
4 way shell VH396-04H
Crimps for the above: VH396T-L

But is there anywhere I can buy them with ok shipping? I only found toby.co.uk where the connectors will be around 8£, but the shipping to denmark is 22£.

@deckingman your time to shine

What about In your home all file to make the printer "believe" it have been homed IN XY first (I think its just to set G92 X0 Y0) and then home Z, and then home X and Y