That’s awesome thanks. I’d be more than happy to design and print my own housing and put it together myself.

Please ... take my money

I’ve noticed the Rotating Magnet version of the filament run-out sensor is out of stock. Is there a plan to manufacture more? The added information from it really suits my current requirements.

Many Thanks
Mark

Thanks for the very quick response - I really appreciate it.

Hi - I bought a duet wifi and PT100 board from e3d and I'm assembling my new printer with this setup. I'm having an issue with one screw terminal it's spinning and not engaging. A such, I'm not getting a good connection and am getting a heater error against the dodgy terminal. I've not over-tightened anything.

E3D are willing to replace, but require a statement on the duet forum that I do have a physical fault. Can you reply in this post that I have an issue with one of the screw terminals.

Thanks
Mark