Hello folks,
I'm a real newby in the "world of codes".
Lately i bought a tevo little Monster (occasion) to build some bigger parts i need for my gollowing project.
Now: i had to make several changes to make the printer work again. Additionally a added 3 springs under the bed for manual leveling.
This set the bad heigher than before.
Auto calibration still works with this height of the bed.
BUT now: I'd likd to add a new plate onto the bed. Again 4mm of material.
These 4mm would make the hotend crash into the bed while auto leveling.

What/Where can I change a Z-setting, so this could be fixed?

Thank you very much for your help!