@phaedrux Ok, So I turned that back on. I know I don't use that for the Ender 6 but that is a Marlin system.So Turn it on in slicer yet M83 at beginning o fthe END GCODE should stop the retraction at the end of the print. So confused. But I will try that. Thank You!
Posts made by Magicwood
-
RE: Full retract when completeposted in Tuning and tweaking
-
RE: Full retract when completeposted in Tuning and tweaking
@phaedrux Ok, Thanks. I found that and turned it off. I also saw something about putting M83 at the beginning of the END GCODE so I added that in there. Hope that was correct!
-
RE: Full retract when completeposted in Tuning and tweaking
@peter247 I have the exact same problem. Hope you found a solution. Still searching.
-
End Gcodposted in Duet Web Control
I am using Cura and then web control to slice with my duet3D 2 printer. Use to be a Crane Quad but converted to a single head bowden tube printer. Problem is everytime I make a model. At the end of the print it completely removes the filament from the printer. Backs it all the way out. Thinking maybe a gcode command in the end gecode of Cura. How can I prvent this retraction when finished. 20mm maybe but all the way out. No way! Here is my end Gcode settings.
G91 ;Relative positioning
G1 E-2 F2700 ;Retract a bit
G1 E-2 Z0.2 F2400 ;Retract and raise Z
G1 X5 Y5 F3000 ;Wipe out
G1 Z10 ;Raise Z more
G90 ;Absolute positioningG1 X0 Y{machine_depth} ;Present print
M106 S0 ;Turn-off fan
M104 S0 ;Turn-off hotend
M140 S0 ;Turn-off bedM84 X Y E ;Disable all steppers but Z
Kinda new to this stuff.