@droftarts said in Heating up bed error since update to RRF 3:

M307 H0 D30

Thank you so much Ian, it worked!
Sorry I must have overlooked this information for myself.

Now I can fine tune it for the better.

Lucien

Thanks droftarts for the quick response.

I tried this actually this morning after I got the first warning, but couldn't get a proper result as I get the "Auto tune cancelled because temperature peak was not identified"

I tried this 3 times in a row (M303 H0 S50, as that's my mostly used bed temp), with always the same result. PID tuning the nozzle heater, no problems though

I'll give it another try later

p.s.: I use the simple glass bead sensors. [Y"thermistor" T100000 B4138 R2200]

Hi all

I just updated to RRF 3.01 rc6, before I was on 2.x, did the necessarily config updates and now I get the error message:

"Error: Heating fault on heater 0, temperature rising much more slowly than the expected 1.7°C/sec"

I know my bed heats up very slowly (330x330 aluminium plate, but that has never been a real deal breaker for me, till now. It takes normally around 15m to go to 60C and that's OK for me.
In the versions before RRF 3.0, I never had this problem ?
Is there a way to change the temperature rising parameter per second, somewhere?! Or other g-code to accept slower heaters?

Thanks for your help

Lucien
Duet Maestro 1.0

@lulu3d Here is my menu, largely based on others work, but with a main menu status screen showing simple icons. Of course you'll have to adapt it to your taste and wishes. The preheat menu uses my preheat macro's, you'll have to create your own.

https://1drv.ms/u/s!Ao5r7Mz_5rhOhJJg8VJNabWS_QFtlg

Enjoy, adapt, make better and share

Working on it. Will post my basic menu structure when I'm happy with the result (with basic menu icons..., yes)

Would love to see smaller fonts though even F0 is a bit 'big'

Is there a possibillity to have the dial knob working inversed for dialing in 'alter' values?! I like, how it dials the menu, but would prefer to see an inverse dialing in values (alter) Now when turned c.c. values are raising and c.w. deminishing

Just a preview:

link video is here