Posts made by LucasCarreno

I have a problem that happens to me when using Cura and it is that at the end of the print, just at the last point where the nozzle is passing, it stops and begins to retract the filament without stopping or moving in any direction for approximately 40 seconds . After this time, the printer executes the part presentation code without problems. I tried several laminators and it only happens at the end of printing a gcode from cura, the same does not happen with simplify 3d or with prusaslicer. Does anyone know what it could be? Attached is a photo of a calibration cube, where you can see the result of the problem.

This is mi config file
config.g

I am trying to convert an old replicator 2 with a duet 2 wifi board, when configuring the firmware all the motors work fine except the z axis motor, it has an erratic behavior, it turns to both sides and sounds a lot, I already checked the polarity and also update the firmware to 3.04 but there is no way to fix it. Then I modified the velocities and accelerations and got the motor to move a little more uniformly, since I had read that this problem was due to the low speed in the z axis but now it throws me this problem "Warning: Driver 2 warning: phase A may be disconnected, phase B may be disconnected."
Your answer is probably to reverse the polarity and check the wiring, but the motor doesn't run when you reverse the polarity.
Which may be?