I preformed a clean install of windows 10 and loaded 18(beta). It worked. I think I had a conflict or corruption that needed to be removed. Now on to the z probe . . .
Latest posts made by Lchappell
-
RE: It started with an inability to run Z homing.posted in Firmware installation
-
RE: It started with an inability to run Z homing.posted in Firmware installation
Yes, Bossa Program Port is showing in Device Manager. Connecting through Sam-ba gets "error h_handle returned zero."
-
RE: It started with an inability to run Z homing.posted in Firmware installation
Sam-ba can't connect to at91sam4e8-ek. I've tried to re-install Sam-ba with no success. Please advise.
-
It started with an inability to run Z homing.posted in Firmware installation
Hello,
I was able to home the X and Y axis, but the hot end would not stop when the end stop was triggered on the Z axis. I tried to update my firmware (after trying many of the suggestions offered in the forum), but I still had the Z homing issue. Then I attempted the three fall back procedures. Now I cannot connect through wifi, Pronterface, or Sam-ba. The board shows as "Bassa program port" under the USB heading of my device manager. Is there a work around to revive my Duet Wifi?