@dc42
Just a quick reply...
I replaced the mosfet with:
AOSS32334C
It was a little challenging to solder but I could replace the part and the board just works fine again.
Thanks for the support.
@dc42
Just a quick reply...
I replaced the mosfet with:
AOSS32334C
It was a little challenging to solder but I could replace the part and the board just works fine again.
Thanks for the support.
@oliof said in Filament diameter tolerance compensation:
Schnekenstruder
Thanks oliof for your quick reply.
The printers extruder is based on two belts transporting the material. The Belts eliminate any grabbing into the material and the feedrate is not influenced by any change in filamentdiameter that results to another circumference on the driving wheel.
The filament used is a WC-Co-filled fialement which is extremly brittle. I am not sure if such a rotaryextruder (simmilar to fuselab-design) might work.