Best posts made by Killernoy

@T3P3Tony I think I've read your article about the Kraken when I first looked into buying one.
So no mesh bed compensation for me then.
Thanks again for the help.

p0.9 did the Job
16:04:42M307 H0
Heater 0 model: gain 159.6, time constant 1084.6, dead time 50.7, max PWM 0.90, calibration voltage 24.1, mode PID, inverted no, frequency default
Computed PID parameters for setpoint change: P23.9, I0.102, D849.4
Computed PID parameters for load change: P

16:03:01Auto tune heater 0 completed in 1388 sec
Use M307 H0 to see the result, or M500 to save the result in config-override.g

15:46:21Auto tune phase 3, peak temperature was 64.5

15:45:22Auto tune phase 2, heater off

15:39:58Auto tune phase 1, heater on

15:39:52M303 H0 P0.9 S60
Auto tuning heater 0 using target temperature 60.0°C and PWM 0.90 - do not leave printer unattended