Hi,

Since a few month I have trouble with the Wifi connection. My set up is a Duet 3 Mini5+ Wifi, the distance between the Wifi router and 3D printer is about 4 meters. Wifi signals on my other devices are stable.

The commands I give in Yat are:

M115
FIRMWARE_NAME: RepRapFirmware for Duet 3 Mini 5+ FIRMWARE_VERSION: 3.4.4 ELECTRONICS: Duet 3 Mini5plus WiFi FIRMWARE_DATE: 2022-10-20 16:18:28<LF>ok<LF>
M552 S-1
ok<LF>
M552
WiFi module is disabled<LF>ok<LF>
M552 S0
ok<LF>WiFi module started<LF>
M552
WiFi module is idle<LF>ok<LF>
M587 S"XXXX" P"YYYY"
ok<LF>
M587
Remembered networks:<LF>TNCAPF318D9 IP=192.168.1.24 GW=0.0.0.0 NM=0.0.0.0<LF>XXXX IP=0.0.0.0 GW=0.0.0.0 NM=0.0.0.0<LF>ok<LF>
M552 S1
ok<LF>Error: WiFi module reported: Unexpected WiFi state 'idle' while trying to connect to <LF>WiFi module is idle<LF>Error: WiFi module reported: no known networks found<LF>WiFi module is idle<LF>Error: WiFi module reported: network scan failed<LF>WiFi module is idle<LF>

The name off my Wifi network is XXXXX in this try out. The blue led don't blink on the board. It is very strange for mee because sometimes it wil work without problems. Since last days there is no Wifi connection with the board

Is there a solution for this problem.

Best regards