Alright, so my first mistake was not properly flashing the board with the latest firmware. I was able to jog the carriage and bed around before I properly flashed and noticed how silent the motors were. Then I flashed with 2.05.1 and the motors are making a noticeable noise. I checked M569 Pnn and it says stealth chop is enabled. Video linked on the imgur album.
Second issue, the first time I ran the bed mesh it came out fine. My bed needed some adjustment so I ran it again, but then it looked way off so I watched it the third time, and the nozzle was being pushed into the bed. The probe was triggering, and the web gui can see it triggering, but its only getting pushed into the bed on specific spots. Though that didn't happen at all on the first mesh. Photos linked in the imgur album below. I think its possible my ezabl may have taken a shit, though I am curious if this is an operator error.
https://imgur.com/gallery/Xw8sPVr
Thanks for your help in advance, loving the duet 2 maestro so far! The web gui is such a nice feature.