Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login
    1. Home
    2. JonnyBrylcreem
    3. Topics
    • Profile
    • Following 0
    • Followers 1
    • Topics 5
    • Posts 29
    • Best 2
    • Controversial 0
    • Groups 0

    Topics created by JonnyBrylcreem

    • JonnyBrylcreemundefined

      Unable to control part cooling fan from PanelDue

      General Discussion
      • • • JonnyBrylcreem
      8
      0
      Votes
      8
      Posts
      406
      Views

      JonnyBrylcreemundefined

      Thanks for the info. I will swap my fans around when I get a chance

    • JonnyBrylcreemundefined

      Homing Issue

      General Discussion
      • • • JonnyBrylcreem
      6
      0
      Votes
      6
      Posts
      298
      Views

      JonnyBrylcreemundefined

      @Phaedrux I think you are probably right. I haven't had chance to test your theory yet, as I've been sidetracked trying to iron out all the other little issues, but it would make sense. As you say it won't stop me printing . I just couldn't figure it out and it bugged me.

    • JonnyBrylcreemundefined

      Homing issue when transfering to Duet Wifi from 0.8.5

      Tuning and tweaking
      • • • JonnyBrylcreem
      4
      0
      Votes
      4
      Posts
      536
      Views

      JonnyBrylcreemundefined

      After updating Firmware to 1.21 and tweaking a few settings it now works fine. Thanks again

    • JonnyBrylcreemundefined

      Wiring query for always on fan on Duet 0.6

      Duet Hardware and wiring
      • • • JonnyBrylcreem
      11
      0
      Votes
      11
      Posts
      1.4k
      Views

      JonnyBrylcreemundefined

      Thanks for the offer but I think I am going to pull my 0.8.5 board out my other printer, use a Duet WiFi (that I've never got around to using) in the Ormerod and then use the 0.8.5 in this delta

    • JonnyBrylcreemundefined

      Issues addressing Duet 0.6

      General Discussion
      • • • JonnyBrylcreem
      23
      0
      Votes
      23
      Posts
      2.9k
      Views

      JonnyBrylcreemundefined

      😃 VICTORY IS MINE!

      @dc42 @ayudtee @Phaedrux thanks for all your help.

      @dc42 I had come to the conclusion it was a comms issue causing the reset as I had traced the fault to only occurring when the Ethernet port was connected to the network.

      I've given the board a static IP address and that seems to have cured the problem. I'm afraid I was unable to look at the "last reset reason", the board just didn't want to report back.

      I will give the new firmware a go at some point, first of all I want to finish putting the printer together and try to get it to print something!

      Thanks again

      Jon