Posts made by Joeyhershey

@dc42 so do I need to combine the two codes into one with using the M401 &402 code??

I so the issue I'm having is that after the probe does the bed leveling it docks the probe and then goes and picks it back up to do the bed mesh. these wastes time docking and undocking.
How do I stop this? Do i need to add a code into my slicer??
bed.g
mesh.g

@Phaedrux Would setting up the Duet 3 with a SBC help me with this connecting issue? I was able to set the duet up in Access Point Mode and i was able to get to the DWC with no issues. So i removed the remembered networks and tried to connect to my wifi ( not the guess) and i couldn't i keeped getting WiFi reported error: no known networks found<LF>.
Would setting it up with a SBC fix this issue?

@Phaedrux I haven't done anything with macros before. how would i set this up?

@Phaedrux With the eero i can turn off the 5ghz for 10 mins to try to connect the duet. when i do this the board won't connect.

@Phaedrux So i conected my commputer the the guess and the computer has a different IP address. I also tryed to connnect the Duet to the normal wifi and it wont connect i just keep getting.....WiFi reported error: no known networks found<LF>

@Phaedrux When I get home from work in the next 2 hours I will connect my computer to the guest network and see I can connect to the DWC with the IP that the duet is giving me. I will let you know what happens.

@Phaedrux When you said the first 3 i thought that meant 192 not the first 3 sets of numbers. Sorry thats my bad.
So something i should of stated also is that my duet is connected to the guess network as my normal WIFI password has the special charterers that the duet doesn't like. So duet is on guess and computer is on normal wifi. Can this be why when i type in the address the duet gives me on my computer it dosent load??? If this helps i have the eero router.

@Joeyhershey this is what i get.

@Phaedrux I am on my way home from work 30 minutes. I will do the ping and I'll send you a picture of what I get.

@Phaedrux no its still down. how do i ping the duet ip from my computer??

@Phaedrux Yes it does.

@Phaedrux I can switch my internet to 2.4ghz and it connected. When I run M552 with the USB I get 192.168.11.20.

Hello everyone,

I got a new internet provider and after i reconnected the duet board to the new internet the DWC does not open. Any thoughts on how to fix this?? i might have a rolling ip address also now.

@phaedrux ohhh ok that make since too.

@phaedrux ok yea I just deleted everything in the folder and i still cant. ill do it through the PC.
Thanks for the help!! I'm new to duet and couldn't figure this out.

@phaedrux yes i just did that and it works now. i was trying to update it yesterday and i think i did the wrong file and now i cant delete it. how can i get this out of the system tab??

@Phaedrux I am running firmware 3.3 and it show that DWC is 3.2.

Hello everyone,

I am new to duet and im having some issues with getting the height map to work.
I run the G29 and it completes it but i dont get anything on the height map other than it saying invalid height map.
Can anyone help me with what to do to fix this??

Thanks