Seems I just had the wrong value in my retract macro… awkward
Posts made by Jdn-za
-
RE: BLTouch working
-
RE: BLTouch working
Ha! seems my signal wire was busted
My deploy marco works though the retract doesn't
deploy
M280 P3 S10 I1
retract
M280 P3 S90 I1
If I home Z it deploys, lowers and reads the height then deploys and flashes
-
RE: BLTouch working
Are you on duet 0.8.5 or duet wifi? I have BLTouch wired up with my wifi working well.
it's mostly the same instruction that W3DRK but the expansion header is not the same on the wifi so you would have to use pin 8 for Heater 3 pwm output instead.
see documentation here : https://duet3d.com/wiki/Duet_WiFi_wiring_diagramsI am using the Duet 0.8.5
-
RE: BLTouch working
W3DRK, So I have wired up my bltouch int he way that have described but cant seem to get my duet to deploy or retract using macros or gcode.
I have the following defined in my config.g
; BLTouch M307 H3 A-1 C-1 D-1 M558 P4 X0 Y0 Z1 H3 F200 T5000 G31 P200 X-4 Y40 Z2
I am running the latest stable dc42 fork of the Duet 0.8.5 firmware
Firmware Version: 1.17a (2017-01-02) Web Interface Version: 1.14-RC1
Any ideas what to look at?
-
RE: BLTouch working
Just ordered myself a bltouch and will be adding it to my duet 0.8.5, thanks for documenting the install mate