Best posts made by jballard86

@mrehorstdmd

There is a Kinimatic bed mount system available for the Railcore produced by Mandela Rose Works:
Kinematic Mount

@dc42

here is a more up to date config, that is actually printing right now (with shifting) config (1).g

and here is a the console output after running a few M122 commands for the 1XD boards and the main Duet console.txt

This was while printing the standard Benchy model. no hiccups at all. But plenty of shifting, there are no skipping/slipping belts.

I use Notepad++ works flawlessly.

@dc42

4.99v on 40
4.97v on 41 Likely due to the R18 and R20 tolerances.

Did the same test with the servo encoders with the following results:

RAS 6.2	RAS 6.2		
3600 pulse/rev	3600 pulse/rev		
			
Servo Encoder at X0 Y0		Driver board position at X0 Y0	
A	B	                B41	B40
-12564	23112	               -49695	13499
-12289	23124	               -49695	13499
-12031	22945	               -49695	13499
			
no change with or without RAS			

Unless you have any other ideas I feel like the Clearpaths are not compatible with the 1XD board for some reason, Ill contact Teknic to see what their thoughts are.

@dc42

After more research I have found multiple instances where Clearpath Servos are very picky about the signal voltage. Ive designed a small level shifter board and sent it off for a prototype run, I hope to have it in about a week or so. I will be shifting the signals to 12v.

Once the boards and components arrive Ill test the boards, then test them with the servos and ill update.