Best posts made by JawsN3D

Finally have 98% of this thing sorted out. I've done my damnedest to make sure I haven't had to ask any stupid questions......
..... like how the hell I ended up with bed one and bed two with the hot end thermistor tied to bed number two.....weird.
Most of what I've dealt with are errors with converting my stuff to 3.0 + from 2.03.

Anyways figure you all might want to see our "bigger boat"
We are using it to make parts for our Oldsmobile.

Duet2/duex5, now with 3.3 on it and the paneldue....n some other stuffs.
I drew out and waterjet it...and a bunch of more minimalist brackets etc that it has 2 smaller brothers.
This is a little older video but it gives you a good view of all the important stuff.
https://youtu.be/Ua9t-zh2tIw

@fcwilt
Homing has been good since I finished the new rrf3+ syntax...only in the last 2 weeks ive had it bounced off of and jamming into the end stops a few times before I ever even commented out the m-84...
It actually seems to be doing that more and more.
which is why we're going to at least swap to a different SD card for further testing.

@fcwilt our cold bed is 1/2inch 6061 plate with the hotbed above it being 1/4inch plate....pretty heavy bugger.

Mesh is slow but it shouldn't need to be probed often

@phaedrux

ah yes it should take a minute. i had it set slower to confirm homeall was being run. i never timed it but it was far longer than the x,y,z individual macros.

i havent gotten around to commenting out homeall from the bottom (g30) up and do some trial and error testing with g28 re-enabled in start.g

we sorta have it pulled apart at the moment, trying to do optical end stops for a "softer" home stop, as well as a second x endstop for the y to home perpendicular to x.

as well as double checking the heaters/hotend wiring to make sure i only have a code problem causing the extra heater display.

so Al or I will update this as soon as possible.

Regards, James W