Posts made by jan19

Great, thank you!

I have just been converting a CNC router to a duet 2 ethernet board.
Everything seems to work fine.

I am running two seperate steppers on Y with an endstop each.

Using marlin I used to be able to square off the axis perfectly by setting up an offset for the endstops using the M666 command.

Is there a way to do something similar on the duet 2?

Firmware is 3.11

I have a piezo sensor.

So if that happens, there is usually a physical problem.
Like a tiny bit of oozing filament on the nozzle I forgot to clean away or something on the printbed.

So only solution at this point would be to probe manually and remove the g29 from the startcode?

I have "G29 S0" in my start code to probe the bed every print.

The problem is, if I have an error during probing, like "Error: Z probe already triggered before probing move started" or not consistent probes, the print still goes on.

Obviously this is not what I want.

So where is my error in thinking there and how do I set it up, so that the print stops/cancels if an error occurs?

Thanks,.
Jan