I am in the US, and i sent W3DRK a message about a week ago with no response…
Posts made by j1999t
-
RE: Maker Select V2 w/ duet wifi-heatbed connector melted?posted in Duet Hardware and wiring
-
RE: Maker Select V2 w/ duet wifi-heatbed connector melted?posted in Duet Hardware and wiring
Would anyone be interested in performing the repair ?
-
RE: Maker Select V2 w/ duet wifi-heatbed connector melted?posted in Duet Hardware and wiring
unfortunately i dont like the printer being down for who-knows-how-long. i ordered a new board, hoping to fix the old one and sell it to make up some of the difference.
-
RE: Maker Select V2 w/ duet wifi-heatbed connector melted?posted in Duet Hardware and wiring
Problem I have run into with the piece is to get one, i have to order 100 or 1000 of them. Crud
-
RE: Maker Select V2 w/ duet wifi-heatbed connector melted?posted in Duet Hardware and wiring
I never tinned them. The stock wiring from the maker's heatbed had ferrules on it, and i used those as the connection to the terminal block. I did fail at checking the screws every now and then.
Unfortunately, I am not experienced in any way on PCB soldering.
I really hope I do not have to replace this board.
Thanks in advance
-
Maker Select V2 w/ duet wifi-heatbed connector melted?posted in Duet Hardware and wiring
Earlier this morning i was heating up the bed for another print and the bed heated, then cooled down and would not reheat. After looking at the board, (see pic below), the green connector is melted and the screw and cable will not come out. Is this fixable?
Thanks in advance,
Justin