@droftarts This fixes my problem thank you.
Latest posts made by Huinker
-
RE: How to print with origin as the center of the modelposted in General Discussion
-
How to print with origin as the center of the modelposted in General Discussion
I use manual homing, I put the printer head in (0, 0, 0) position then I use G92 x0 y0 z0 command to set origin
when I check the g code, it goes to negative x and y showing g code should show the center as the origin. However, when I print, it prints with the bottom front left corner as the origin.
How do I fix this?