Wondering how your progress is going. I'm picking up a 6 axis robot and hoping to use a duet board for main the control. Any advise would be appreciated.

@JoergS5 thank you, I'm in the learning stage myself. This is why I thought it would be a good idea to seek outside assistance.
Cheers for the link gives me plenty of information to go by.

@T3P3Tony I am speaking to a software company this Friday to see if this is possible and potential costing.

@dc42 thank you I will give it a go .

@T3P3Tony thought I should add this would only be for motion.

@T3P3Tony understood, maybe via raspberry pi using python for instant conversion of commands.
I saw a converter on github using python to convert files but could this be done line by line in real-time?

https://github.com/DAguirreAg/GCode-to-ABB

Would be great to use this on the older system s4c, since it has connectivity restrictions as well as memory.

@T3P3Tony thank you this is what is from the description on the website.

Main technical parameters of PT131 melt pressure sensor;

1. Range: 0-200 MPa
2. Accuracy: 0.2FS
3. Output signal: 2mV/V; 3.33mV/V
4. Power supply voltage: 10VDC
5. Temperature models: J, K, E, PT100
6. Temperature resistance of diaphragm: 450 C
7. Temperature zero drift of pressure sensitive diaphragm: <0.3MPa/100 C
8. Electrical Connection: Seven-core Connector Pin

@T3P3Tony apologies for the delay, sensor is a PT131 pressure transducer.

Hoping for some help, looking g at 6 axis robotic printer. I love how easy duet setup is so want to implement control on a ABB 6400R IRC5. What I was thinking is that if g code can be converted to rapid surely the reverse is possible. So wondering if via the can connection would this be possible. Obviously some sort of protocol/board required for can to profinet.
Might be asking too much but never know until you ask.
Main reason for me is I am not very computer literate but can use the duet setup and would be a far easier for me personally.
Look forward to your reply.

@jay_s_uk OK thank you.