Best posts made by holco62

I see it now line 4 and 5 is for the hotend fan that triggers on 45 degree, I only have to put the connector on the FAN1 output which is now connected on a always on output

Have a lot to learn about G-code

Still needed some tuning, but a week ago I did not expect to have a working printer already

https://youtu.be/CeavMw9Q42I

Tomorrow is a new day, I have to go to bed now.

But thanks for all the help

@holco62 said in when will the new Z-height actually be saved?:

Ok it starts to get a bit clearer (very small bit )

Btw, how can I prevent the printer from homing after G32?

I would like to have this sequence,

First manually set bed temp / hotend temp in Duet control

Load print command> homing axes> G32> start printing, so no homing after G32.

Removed the start.g file and added G32 in the Cura exstruder start-g code, everything now works exactly as I want