Topics created by gw3d3

This worked, Thank you!

@chrishamm Thank you I will try this out.

;stop.g keeping dryer active

M104 H0 S0 ;Turn off hot end
M140 H1 S0 ;Turn off heated bed
M141 H2 S0 ;Turn off printer chamber heater

End G code in Cura

;Retract the filament and move tool head away.

G92 E1

G1 E-0.5 F300

G28 XY

M84

M0

@jay_s_uk Thank you, I set the Q value to 25kHz as per Noctua's specs and it is working well now!

@droftarts Thank you all for the replies.

This corrected the issue!

@droftarts So, I'm issuing a correction to my original post.

After using the macro lens on my camera to take a picture of the IC I realized it was the correct part number! I switched from a "J" type to a "T" type in my config.g and it seems to be working now.

I was having an issue with an intermittent over/under voltage error but I crimped up another heater assembly and it seems to be stable. Whether or not it was a bad crimp or the actual T.C. I don't know.

I'm using Igus Chainflex shielded cable which is drained to an earth ground. There is about 5" of exposed, but twisted pair lead from where the shielding terminates to the daughterboard. Is this too much?