Topics created by guerty25

@guerty25 OK lets take another look, because scaling down to 93% doesn't work in the math. Any adjustment to mesh in self printed parts by way of shrinkage is only to take up a couple tenths of a mm at most.

Did you mean 99.3% ? Either way, contact me directly and we can set this right.

you could get a mosquito magnum. it can reach 30-35 mm^3/sec.

I think I experienced the same in 2.05.1 as well but chalked it up do noobishness in actually using the firmware to print. Maestro board, delta kinematics and ATX supply, no sensors at except mechanical endstops. (edit: it threw an error each time we canceled a job during pre-heating, which required us to first pause then stop the job, and issuing M562 to try again)

@Phaedrux Thanks!