@siam thanks for the reply, your suggestion to issue M98 P"config.g" lead me to my mistake.
I had a typo in the IP configuration.
Thanks a lot!
Best posts made by gueee78
-
RE: WiFi doesn't start up after upgrading to RRF3.3posted in Firmware installation
-
RE: Height map has a substantial Z offset error with meshposted in Tuning and tweaking
Hey Veti,
no he's not probing on glass he uses a TH3D sheet, completely opak and it worked flawlessly before. That phenomenonm started to appear all of a sudden with nothing changed. Btw it got better again, but the repeatability is still rather bad.
Switchin the printer off and on again usually trows the settings off by about 0.3mm wich is way too much imo.