I have also this issue with T R1.
After resume:
Error: Attempting to extrude with no tool selected.
I have also this issue with T R1.
After resume:
Error: Attempting to extrude with no tool selected.
@Phaedrux
I used unofficila-3.3beta from 2021.02.01 and "upgrade" to RRF3.2. Now I have sometimes this freezes.
I have exactly the same issues after upgrade to RRF 3.2. The unofficial 3.3 Beta works.
I have SBC Duet3 MB6HC with toolboards 1LC at 3.1 or 3.2
After Reset - Homing all - Tool load - Tool unload - Homing all have I a X-offset off 5mm.
I can print without problems, also tool changes. Only after the 2nd homing have I the offset.
What can I do?
Is ther finally a solution for this error?
config-override.g doesn't override anymore the M307 H1 B0 S1.00
I have now the exact same issue.
I have also this issue with T R1.
After resume:
Error: Attempting to extrude with no tool selected.