@catalin_ro said in Workbee CNC 1500 x 1500 Belt - Duet Z Axis Issue:

Where is you Z0 relative to the workpiece?

Z0 is set to bottom left - I have run a test with the Z at full height and zero'd at full height as it should only move down a max of 6mm for the board I'm trying to machine, however, the Z axis moves all of the way to the bottom hitting the board. All other Axis appears to be working fine.

Hi,
I am in the process of commissioning a Workbee CNC 1500 x 1500 Belt, standard set up from Ooznest. The X & Y axis travel seems spot on, however, when I run the attached G Code, The Z Axis mount travels too far and the bottom of the mount hits the deck.

The Gcode was created in Fusion 360 and the simulation ran as expected. When I measure the travel on the Z Axis by sending 25, 50mm code to the machine, the measurements are fine.

Can anyone assist, 0_1557575473497_Waste Board.txt please?

Thanks