Posts made by Gregk

Please add me to the list as well - thanks.

All is sweetness and light …........ downloaded the 64-bit version of bossa.exe and used the command line as suggested.

Many thanks for your help.

Many thanks for your help, I will try this later after my dinner.

The BOSSA software was downloaded but failed to install because it require a 32-bit machine …............ uggghhhh.

OK ….... plugging the USB lead into the Panel Due v2.0, I get ....."Bossa Program Port (COM18)" and nothing else .......

A serial port shows as …... "Duet 3D printer control electronics (COM19)"

Nothing on the screen but testing the cable from the PCB shows that +4.63v is available.

What should the jumper position be on the Panel Due to set the voltage?

Hi there, I'm new to the 3D printing and having a bit of bother setting the screen up.

So far, I have setup the Duet Wifi with the motors attached and tested it with pronterface …..... all good, but I do not get anything coming up on the panel. The wiring looks good and everything is as delivered. There is a jumper on the Panel Due PCB with the centre pin and pin nearest the speaker connected.

Any advice will be gratefully received.