@droftarts You have been very helpful, thank you! It turns out the problem was that both my password and SSID were lower case and I was not using the single quotes to specify that!
After the duet2wifi is connected to the WiFi (blue led on), should I remove the USB and proceed to the wiring? or what are the intermediate steps?
@giusciccone (after running the M587 command using my hotspot, I don't get any response from the terminal)
@droftarts ok, thanks for the info. Do you think it is possible to use my iPhone's hotspot as a network?
HI @droftarts, it worked!!! I think it was a matter of how I was sending the commands: I did not know that each character went to the duet as I typed them - this made a huge difference, thank you!
Do you have any advice on how to connect it to a network that requires a username and a password? Or whether there is a way around this? I am using it in my university and that's the only network available. @Phaedrux gave the suggestion to configure an Access Point mode of the duet itself, but not sure how to do that.
Thanks!
@phaedrux I don't have access to the duet2wifi now, but when I was trying this morning it seemed not to work, as when I ran the command to get the firmware version (after running M552 S-1) I still kept getting ```
undefined
WiFi reported error: no known networks found
WiFi module is idle
I will try in the morning again when I will have access to the board, and let you know. Thanks for your help!
@phaedrux Thank you! Yes, I have tried step 7 but it gives the same error specified in my previous post 
Do you think changing the baud rate would help in any way? Or any other settings?
Thank you for the advice on the network connection, I will have a look at the link you shared.
Hi,
I am new to the duet world and I am following the instructions here https://duet3d.dozuki.com/Guide/1.)+Getting+Connected+to+your+Duet/7 to connect the duet to my MacBook Pro using SerialTools. However, I cannot get past step 5 of the guide, as all the other steps don't have instructions anymore for the Mac configuration using SerialTools. I keep getting:
WiFi reported error: no known networks found
WiFi module is idle
which from what I understand is normal. However, whatever G code command I run (e.g. M115) to get the firmware version, returns the same error.
Another problem is that my wifi network is a public (university) one called 'eduroam' and required both a username and password to set-up. What command should I use to get my duet wifi connected to this?
Any help would be greatly appreciated,
Thanks,
Giuseppe