More or less the same request but additional uses.
https://forum.duet3d.com/topic/5370/m106-feature-request-limit-max-pwm-parameter
More or less the same request but additional uses.
https://forum.duet3d.com/topic/5370/m106-feature-request-limit-max-pwm-parameter
Yes, and limiting the max PWM is to mistake proof and protect against damage.
It would be more applicable to brushed motors than brushless motors
It would be nice to have a M106 parameter similar to L that would limit the maximum PWM value for a fan.
Usage:
For what it's worth, I've seen two pancake steppers from a well known extruder manufacturer fail.
One was a short like dc42 is suggesting and the other had weak/failed permanent magnets in the rotor. Running a stepper too hot can cause both failures.
I've been using the Atomic Carbon Fiber PETG in a CoreXY for all motion components and love it.
When comparing prices, Atomic Carbon filament is a full 1kg spool at less cost than a 3/4kg spool.
I've just completed a 10.5 hour print on this release without issue. It appears to be stable with the exception of the weird simulation hang. After a hard reset, the simulation ran fine.
@hergonoway said in Berd-Air pump configuration notes for Duet users:
So you've set M106 with F25500 as PWM frequency parameter? I've got the same configuration and mofset is well cooled, just asking before changing the configuration.
Correct, I'm using F25500 on a 24V (1.03 Duet Wifi) and 12V (0.85 Duet) without issue. I've got a flyback on both. The 0.85 needs the external flyback, but the 1.03 does not. I am not using the eSwitch module.
@gen2eng said in Firmware 2.0RC2b/1.21.1 RC2b released:
It was hanging at about 41sec. I did a hard reset and simulation ran fine on a different file. After the current print job finishes, I will try again.
I tried the simulation immediately after the upgrade. Any chance it needed a hard reset?
I'm running on a 1.03 Duet Wifi.
Ran it again, and it did not hang. The original hang was around 41% complete, not 41 sec.
It was hanging at about 41sec. I did a hard reset and simulation ran fine on a different file. After the current print job finishes, I will try again.
I tried the simulation immediately after the upgrade. Any chance it needed a hard reset?
I'm running on a 1.03 Duet Wifi.