@G-druckt Thank you Ian! yes i think i can write my Problems in English, too.
I think the Problem is in the Start Gcode in the Slicer, is that possible? Can you help with orca, too?

Good morning
someone here still alive?

@oliof Hm
es gibt hinten am Druckbett einen Taster den er beim homen mit der Noozle drückt.
Danach holt er die Clicky Probe und macht das Mesh?!
das Macro hänge ich auch bei.

homez.g
00_magprobe_do_QGL.g

@oliof config.g

Vielen Dank für deine Unterstützung!

config.g

0.02mm +/- über das Panel einzustellen

das ist mein aktueller Start Gcode im Orca Slicer
G90 ; use absolute coordinates
M98 P"/macros/job_start_check.g"
;M98 P"/macros/speed_printing.g"
M83 ; extruder relative mode
;M204 S[machine_max_acceleration_extruding] T[machine_max_acceleration_retracting]
M104 S[first_layer_temperature] ; set extruder temp
M140 S[first_layer_bed_temperature] ; set bed temp
G28 ; home all
G29 S1; hole Mesh
M376 H5; Set bed compensation taper
G1 Y1.0 Z0.3 F1000 ; move print head up
M190 S[first_layer_bed_temperature] ; wait for bed temp
M109 S[first_layer_temperature] ; wait for extruder temp
G92 E0.0
; initial load
G1 X205.0 E19 F1000
G1 Y1.6
G1 X5.0 E19 F1000
G92 E0.0
; intro line
G1 Y2.0 Z0.2 F1000
G1 X65.0 E9.0 F1000
G1 X105.0 E12.5 F1000
G92 E0.0
;M572 S0.05 ;Pressure Advance

Hey together,
i bought a Voron Printer with RepRap Control. I never had RepRap before. so i am an total Newbie.
This is the Configuration
Duet 3 Main Board
Duet Tool Board L1C
Duet 3 Exposion Board 3HC Panel Due 7i

i use the Orca Slicer with the Duet Web Control.
The printer works basically, but i have terribe First layers.
When i make G29 0 for a new hightmap and aktivate this, then i make the Z zero and type the correction in Config G31...
the Distance from Noozle to Bed is with a new printstart too near. the noozle is scratching to the bed. when i adjust the baby steps the print is fine.

I tried to find a Problem but i cant. I need your help.

Thank you soooo much!

Best Regrads,

Daniel

preferably in German

@oliof thank you so much

@oliof Thank you!
and can you help me to adjust that?

Good morning,
I am the new one here in the forum. I am an absolute newbie and beginner. I bought a used Voron printer with Reprap.
Duet 3 Main Board
Duet 3 Tool Board L1C
Duet 3 Expansion Board 3HC
PanelDue 7i

I would like to use the Orca Slicer. I have loaded the preset for the Voron, sliced a model and transferred it to Duet. The print does not start and goes straight to 100% completed without anything happening. I don't know which sub forum is the right one to ask this question and get help. Thank you very much!

Best Regards,
Daniel