Hello,

i wired a emergency stop and connected it to a free input (24V, normally closed). It is working but i want it to be more than just a trigger. As long as the button is pushed i dont wont the printer to run. Right now i can reset the printer although the button is still pushed.
Is this possible?

Duet3 6HC

M950 J4 C"io4.in"
M581 P4 T0 S0 R0

Greetings
Frosch

I connected only 2 of the 3 wires and it seems to work fine. I'm not sure about the accuracy of the sensors, they seem to be a little bit off but thats fine for me.

Topic an be closed! Thx for the help

Hello,

I'm using 3 PT100 3-wire sensors and I'm not sure how to connect them.
All the instructions are for 2 or 4 wire sensors.
I use 2 PT100 Duet3D daughter Bords.

https://docs.duet3d.com/Duet3D_hardware/Accessories/PT100_Temperature_Daughterboard
Here it says 2,3 or 4 wire PT100 sensors but all the following instructions are only for 2 or 4 wire.

I hope i dont have to change my sensors....

Greetings
Frosch

Thanks a lot guys, you were right (of course)

Sensor is now working like a charme
not sure how to set the topic as solved...

My config is M574 X1 S1 P"!io0.in" and i get " X: - not stopped". I get the same result with a srewdriver on the sensor (24V gone and light off, sensor is working).

With M574 X1 S1 P"io0.in" i get "X: - at min endstop". Again with and without screwdriver...

Hello community,

i have a Duet3d 6HC Mainboard and i try to upgrade my existing 3D printer.
I have inductive endstops on all 3 axis (https://de.farnell.com/panasonic/gx-f12b-p/sensor-4mm-pnp-nc-2m-kabel/dp/2357991).
The sensors are connected directly with my 24V power source and i wired only the signal wire to the input pin. When using a multimeter i measure correctly 24V and 0V depending of my axis, but the software is not reacting in any way.
The sensor is normally closed, so my config.g is M574 X1 S1 P"!io0.in". But i tried all other combinations aswell without any result.
Am i missing some electronic basics? (I'm more the mechanical guy...)

Maybe someone here can help me, would be great

Greetings
Frosch