Hi I recently changed my x carriage and its has a different layout for the BL touch, ive put the new layout in the probe offset but it seems to be ignored on homing and the nozzle is going to centre not the probe, it doesn't seem to matter what offset I put it always homes to the same place, previously it would bring the bltouch down on the centre of the bed, any help appreciated

Thanks all, that's solved, my old marlin based printer would use the offset homing z, this doesn't so when id lined up the probe with bed centre it was 35mm out ( the offset) all adjusted now and seems fine

Having a thought about this, during what commands is the offset used ?

Can anyone help on this, this is my first duet so may be missing something. I have a p3 steel frame based printer that ive set up with a bltouch, it all works and homes fine and ive tweaked the axis setting so that the Bl touch pin comes down exactly on the centre of the bed, but when I start printing if starts way to close to the edge instead of at the centre. ive set the offset in config.g ( printer nozzle is 35mm in front of the probe) but it doesn't seem to take that in to account when the print starts. any help would be appreciated

that's the same one as I have

Thanks ill give them a look, the p3 steel can be a bit of a nightmare as there seems to be a lot of variations with different hole placement, tried loads of power supply mounts before I found one that fitted mine

Thanks all, I was hoping to mount to the frame but I guess ill go with the external box for now. Just need to sort out the x idler on the frame then time to wire up my first duet, I think I have the setup done correctly ( with bltouch) but I wouldn't mind a look at your Whosrdaddy if you don't mind ( im using 200x200)

Hi there new user to the board so apologies if this is the wrong place. im currently upgrading to a p3steel frame for my 3d printer and have a duet wifi to run it. im just wondering if anyone has done this and if so do you have an stl on how to mount it to the frame ?