thanks
I managed to get it connected but the web interface is gone, I get a black page on safari and cannot connect on chrome using the IP I retrieve
Latest posts made by fpex
-
RE: Cannot connect after update to 1.20
-
RE: Cannot connect after update to 1.20
How do I remove all the wrong upped networks?
-
Cannot connect after update to 1.20
I have upgraded via the SD, since it was a very old firmware. This first M997 S0 and then M997 S1 from pronterface.
The net result is that now the board no longer connects to a WIFI.
I followed the steps as form the guideM552 S0
M587 S"ssid" P"passed"But it does not work. It seems that the board makes all I give as ssid/psswd uppercase and of course it does not work.
The AP also iOS no longer working, therefore M552 S1 results in no known networks and no more AP.If I try to reinstall the firmware, it simply deletes the bin file and claims it is not there.
I am kind of lost. Any help is welcome.
Thanks -
RE: Kossel with diamond head
Wiring and firmware settings for a kossel with a diamond head. Any info I can use since I haven't found much around
-
Kossel with diamond head
I am now finally, after a couple of years, my kossel with diamond head and duetwifi.
Any pointer to where to start to look at.I am currently at the wiring stage with the entire frame and alike built and tuned.
Thanks.
-
RE: Diamond + Kossel + DuetWifi
Now that i am a big piece forward I am facing a little problem. The two boards are quite large and the way the connectors are done it is impossible to put it in the base of a kossel (except when I give up height and make a much deeper base). The only options I see are either an external box with boards backt to back and push-pull fans in between. Or place them flat (next to each other) in the top of the printer.
For the latter I would need a shorter ribbon cable though. -
RE: Panel due covers
I think I would reach max 110 if I put the electronics with the screen on top, less otherwise.
Thanks. Once I start wiring … the fun will start (hoping the duet will work ) -
RE: Panel due covers
Thanks, I was considering at the bottom to reduce long cables. With the duet I do not plan to use the SD card (never did on it before) as the wifi web works very well.
Is there a constrain on the length of the axis motor cables? I still need to decide if to place all electronics aside with the supply or on the back axis or on the top. The screen will go then on top in front (or int he worst case suspended on a front axis)btw mine is a Kossel XL, so it is rather tall
-
RE: Panel due covers
Anybody did designs for placement at the base of a kossel? Would spare e loads of time!
-
RE: Lighting LED
HAs anybody a step file of a diamond hot end mount (kossel better) since mine just broke at the first moment (by hand even)