Posts made by Etznab

Finally got the new twisted pair wire ran and while the ohm readings are the same, the temp readings are now correct. Looks like noise was the issue, thanks for pushing the wires. Next step is building a oscilloscope.

Using a quality multimeter (Fluke 77 IV),

With jumper wire direct from the sensor, I set the temperature to 180c. The sensor was reporting 382 ohms when the board said it was at 180c.

I have ruled out anything in my wiring as far as shorts.

To eliminate the noise issue, I routed shielded and twisted pair wire separate of all wires with and without the motors enabled.

I don't have a spare PT100 sensor to compare against so all I could do is test what it was sending. With probes hooked up, I moved wires around to see if there were any drops or rises. There were non and it stayed consistent at 108.6.

I currently don't have a 100 ohm resistor to test the board. I did verify that the wires going into the board are reading 108.7. I rewired all jumpers for a 2 wire setup and verified continuity across contacts.

If the board is good, I am at a loss.

Solid. Channel 200 gave me spikes before it went out.

This setup has been working and printing just fine on channel 201. It stopped reading in between prints. I contributed channel 200 going out due to firmware tweaking but know I am having second thoughts.

That is the confusing part. I am still getting 2000c with the original wiring while it is pushing 109.6, triple checked.

The difference between channels is consistent and repeatable using fresh wire.

I will give the 4 wire option a try.

Really confused now. Wire continuity is good all the way to the daughter board. However, when I run a jumper from the PT100 sensor to the board, I get a reading of 30c on Channel 201. It is too high though, should be around 22c. When I run the jumper to channel 200, I get 19c. Checking resistance in the wiring I get 108.6 at sensor, 109.6 at termination to the board and 108.7 on the test jumper.

Is there an auto calibration causing this difference between channels?

Is 1.0 too much resistance?

I am having an issue with the PT100 daughter board failing. I am running a Duet WiFi with the PT100 daughter board and an E3D PT100 sensor. Shortly after getting my printer running it started to show spikes in the indicated temp and shortly failed to read anything other than 2000c.

I switched the sensor to the second channel on the board and it worked for a few days before it started reading 2000c. I checked the sensor and got a reading of appx. 108 ohm at room temperature. The wiring is passing a continuity test as well.

Does anyone know how to verify the daughter boards operation or heard of this issue coming up?

Good evening. I am very new to 3D printing and even newer to the Duet WIFI. I have the BLTouch connected and deploying and retracting. My problem is that I don't fully understand where and what to put into the System Directory XXX.g files and Macro files. Could someone please break this down barney style for me? Thanks in advance.