Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
@phaedrux said in Bad mesh compensation:
It's always best to have the probe as close to the nozzle as possible.
ok I will try to move the probe in a better position. thank you so much.
What temp do you have set in the slicer? The error indicates that you've hit the temp limit you've set in config.g of 290c.
@Ducati87 said in Error: Heater 1 fault: heater monitor 0 was triggered:
M143 H1 S290 ; set temperature limit for heater 1 to 290C
@Phaedrux said in Z height always not respected:
And if you modify G31 to account for the 0.16? (add it to get it closer, subtract to get it further)
I've just done it, I'm going to try.
yes now seems to work....I don't know why! Anyway thank you for your support guys!
seems to be solved. The problem was the nomenclature in C"Mat Fan1". The DWC doesn't recognize that, for which I typed C"fan0" and C"fan2" and miraculously the fans appeared on the DWC. Cattura.PNG
