@phaedrux That did it! Thanks! I can now move all the axis', heat the bed, and turn the extruder motors.

I suspected a version discrepancy between the Maestro FW and Web Control but wasn't sure which to try. On Github there were lots of choices. How did you know what versions of each piece of firmware I should choose?

@phaedrux Yes, I see the DWC page but it says "disconnected" and none of the links on the page do anything. Refreshing the page does redraw it.

I just got an M3D Promega and am trying to get it going. It has the Duet 2 Maestro V1.0 board.
I can connect via Pronterface and USB and an M115 I get:

SENDING:M115
FIRMWARE_NAME: RepRapFirmware for Duet 2 Maestro FIRMWARE_VERSION: 2.02RC5(RTOS) ELECTRONICS: Duet Maestro 1.0 FIRMWARE_DATE: 2018-11-28b1

I modified the machine_access.g file on the SD card to a static IP. I can ping that IP and when I connect in Chrome to that IP I get the DWC page, but it always says Disconnected in the upper left hand corner. I cannot get any of the controls to do anything.

As I'm new to Duet I am not quite sure where to start. Any help will be greatly appreciated!

Doug