Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Best posts made by digiex_chris

RE: zprobe latches in the "high" state
I figured it out! If anyone else runs into this, in the M558 documentation it mentions in one spot that the zprobe pin pull-up is disabled and it needs to be enabled with a ^
```
M558 P5 C"!^zprobe.in" H3 F900 T12000
```
posted in Duet Hardware and wiring
undefined
digiex_chris