Local is Salisbury. Here are some photos:
https://photos.app.goo.gl/d2dNDCupS25bgT9h2

Hello all, I have a Nophead Mendel90 with E3D V6 and DuetWifi. It's been a good printer, but it's only ever been a hobby. The trouble is I have rarely had time to use it over the last 12 months (new baby and other projects…). It just sits in the corner of the lounge making me feel guilty for not using it! So, I've decided it need to go. Preferably to someone who will make more use of it. But is there a market for second hand home built 3D printers? Or would I be better off selling the Duet, V6 and motion frame separately? Where would be the best place to sell it? Are sales permitted here? Any thoughts welcome!

Powering off and on again. USB disconnected, turning ATX PSU off at the wall, then back on again.

I now have physical access! Connected over USB serial, restarted the web server (M552 S0 followed by M552 S1), connected and it all worked as expected. Not sure why rebooting the whole board did not do this… Happily up and running again though Thanks for your time dc42.

Just tried that, it hangs:

[c]PS C:\Users\James> ipconfig /renew WiFi
Windows IP Configuration[/c]
After approx 5 minutes, Ctrl + C
[c]An error occurred while renewing interface WiFi : unable to contact your DHCP server. Request has timed out.[/c]

Unfortunately the baby is asleep in the same room at the moment, so I can't connect via USB right now! Kids, eh?

Right, I got a new router so I need to reconfigure my DuetWifi to connect to it. Since it can't see the original SSID, the DuetWifi goes into access point mode (good). When I connect to the DuetWiFi AP I have the following problem:

Basically my IP address is way out of range. I have tired setting my IP manually to 192.168.1.100, mask to 255.255.255.0 and gateway to 192.168.1.1. I've also tried resetting the DuetWiFi multiple times. Am I missing something? Is there a way to do a "factory reset"? I may take this opportunity to move up to the 1.15c firmware.

I'd like to add my thanks here too! The community around the Duet is by far the most helful and friendly I have come across. It is partucularly helpful having core developers like dc43 and T3P3Tony around and willing to answer questions. Maybe it's becuase we're all mad keen to make the most out of our kit?

So the Slicing recommendations page on the Wiki is a bit sparse.
Does anyone have any Duet specific slicing tips/tricks besides using relative movement?
Have people had better results with a particular slicer, or is this more down to machine/presonal preference?

As batch 5 is still pre-order, I expect they will be the V1.0 boards.

Just had a quick go with this, one thin I noticed was in the homeall.g file the z homing appears to be done at the corner (first point) rather than the middle.