Hello,
I have Modix3D large printer with Duet2 wifi electronic. Small models can be printed perfect, but in large models, there is a issue:
"Printing paused for filament change at X374.6 Y330.2 Z1.9 U680.5"
Issue is happend random after ( 20 mins, 2h or 6h) I am going one month around it. Try change filament brands, different teflon tubes to reduce filament friction, calibrations, remove clog detector wires separately avoid EMC problems and SW setting the clog detector sensitivity.
Now in config file is very large volatility and 500mm for detection (was going from small steps to this numbers)
In the console: M591 D0
Pulse-type filament monitor on pin e0stop, enabled, sensitivity 3.315mm/pulse, allowed movement 3% to 800%, check every 500.0mm, measured sensitivity 3.321mm/pulse, measured minimum 99%, maximum 100% over 49025.8mm
In my opinion, electronic detects in real very small difference 99-100%, in settings is 3-800% but errors still happend sometimes.
Is here any tool or macro to save every pulse of the clog detector and time for analysis, or any other way whre can be the problem?
Thank you, David.