Duet WiFi Card Ver 1.03
Working on installing a BerdAir with the eSwitch Kit... Long story... 2 Days working on why its not working. Card works fine installed and printed some stuff already (PETG) now installing the parts cool part
After doing some testing this is what I'm finding out and I do not understand why?
Always on Fans 1 and 2... I get 24.05 V
FAN0 - Off (M106 P0 S0) I get 24.05 V, On (M106 P0 S255) I get 20.79 V... Wait What???
FAN1 - Off (M106 P1 S0) I get Less than 1 V, On (M106 P1 S255) I get Less than 1 V... Wait What???
FAN2 - Off (M106 P2 S0) I get Less than 1 V, On (M106 P2 S255) I get 24.10 V...OK that seems good..
I was thinking it has something to do with the Jumpers by the fans but they are setup the way I got it and setup that way on my Delta... and work fine there...
Jumper EXT 5V EN is OFF, Jumper INT 5V EN is ON, VFAN Jumper Select is on VIN & V_FAN Not on 5V
Anyone have any ideas why I get this? I'm 100% lost on this one.
Card does not look burnt out at all, only been install a week or so.
Firmware Ver on This card is 2.02(RTOS) (2018-12-24b1)
Not the same as my Delta yet, have not upgraded it yet
Thanks...