Posts made by danny_swbc

CURRENT 1010 config.g PREVIOUS 1010 config.g

so, yet another power cut today and two more pieces of work lost and I still can't figure out the issues

in the config.g file the M911 line is exactly the same

both have resurrect. g and resurrect-prologue and resume

with the current power failure the smaller of the two machines a 1010 I have checked the sd card and it actually has the details of the file it was running saved under the resurrect.g file but there seems to be no way to call that on the web interface.

The previous one had a resume from power cut button or similar as far as I remember

getting really frustrating now especially with a few power cuts each month that invariably happen when work is on the machine

@droftarts it was a Duet 2 as far as I remember, the one that generated its own wifi access point.

I never changed any of the settings other than the ones to designate the size of the work area.

The initial settings as it came saved work zero between sessions automatically and also saved where it was if there was a power cut.

I may have a copy of the old sd card for it somewhere so I will try and see if I can find anything on there no one the newer duet settings.

Thanks

@droftarts sorry its not SBC, its just via the ethernet port which was the same as the previous earlier version of the duet I had and that was fine for saving the work zero between sessions and also for resuming after a power cut. Thanks

I have a hobbyist cnc that has a Duet 3 Main Board 6HC controlling it.

On my previous machine it was the earlier Duet board and if there was a power cut when the power came back on it was possible to resume the job from when it stopped.

The current one does not have this and if there is a power cut and you are several hours into a job it all lost. In addition it will not remember the last work zero position if switched off.

Obviously there is some code that isn't in the current files that was in the last.

I'd like to sort this out as I've just had a power cut that wasted 3hrs of machine time and the workpiece.

Any suggestions?

Thanks