@psychotik2k3
Hi,
The toolboard works for duet3. I am using a duet 2. I haven't made the jump to a duet 3 yet.
As it would entail reworking/wiring my whole setup.

@dc42 Sorry for the delay. I have 2 daughter boards total. Both stacked on the duet ethernet.
The duex5 does not have any daughterboards on it.

HI,
I have a duet ethernet with a duex 5. I have 3 Thermocouples connected to 2 thermocouple daughterboards on the main boards

I was wondering if I could wire in a LIS3DSH. And am wondering which pins I should connect to.

I don't understand the short error from my thermocouple.

If I have a thermocouple and a heater connected to the duet but not in the heater block and I power on I don't have a short.

The moment I put both in the heater block and then power on I get a short.

If I connect the thermocouple after being powered on, I don't get a short.

If I put a continuity tester between the thermocouple wiring and the heater wiring there is no continuity anywhere.

What could be going on?

Latest 2.0.3 firmware. Brand new e3d thermocouple. Haven't heated yet.

Hi all,

I just finished fried a Duet Ethernet (not sure whether it's repairable, but hard to debug as the ethernet card is dead), This happened as I fried one of Moriquendi's latest 1.21 Piezo Z-Probe boards that I just got.
This is similar to another post from another user.

Surprisingly my printer was working fine until went to adjust the z probe. A miniature fire broke out on the Z-probe board, frying the portion furthest from the pin headers.

Now it is hard to say what does not work
From my panel due, I can tell the SD card is read and my settings are alive.
I can not connect through ethernet, since the link is dead. Also no message confirming the IP address comes up (latest firmware)
I could home both the X & Y axis. Didn't try the Z (since the probe board fried)
I have Type K thermocouples, so the thermocouple board reads correctly.
Fans seem to be working.
Heaters are working.
Z probe still receing 3.3V but probably damaged the sensor output.
I am hoping that the mated Duex5 is not damaged.

Trying to figure out if I can just replace the duet ethernet card.

Thanks,
Dan