Topics created by crowem

@Phaedrux
Fixed it thank you. Some how the tool settings got unclicked

i had similar bed issues. very likely, your physical wiring or tubing connected to the print head bumps up against the corner wall or frame of your printer in this corner, and it slightly pushes the probe and print head downward, appearing like the bed is raised. Since it only happens in that corner, very extreme, it very likely is physical force on your toolhead.

@crowem I use the Noctua 4010 fan with Duet 3 Mini 5+ and like dc42 said, i connect to the 4 pin PWM port as follows:

GND not used VOUT+ Red Wire out.tach Yellow Wire out- Red Wire

this gives the full functionality showing the RPM as well.