Ultibots D300VS (delta style) running a Duet Wifi at latest firmware 1.18.1. Interlink Electronics FSR w/ JohnSL FSR Endstop Controller…

Prints come out ok but i notice that the G32 calibration is always off just a bit at the same angle. I say this because on one side of the first layer the lines have just a bit of space between them and on the other side the layer is obviously squished a bit. I run the G32 before each print and each print i see this same thing in the same direction.
Adding mesh compensation removes that problem but then tends to have the same "issue" but in different areas each time G29 is ran.
Since im calibrating each print and it seems to be calibration that's off a bit i wasn't sure if there was anything in my config to share.
My bed file is generated using the wizard at escher3d.com (13 points, 6 factors, probing radius: 120)
Thoughts?

As an additional note, it just dawned on me that the mesh compensation map shows this "error"... Not 100% sure what that means yet though... Other than useful for visualizing the problem and confirming when its resolved.

Thoughts? hehe