Please add inverted M80/M81 for meanwell PSUs.
I know. I'm inpatient. Is it a lot of work to implement this?
Best posts made by copystring
-
RE: RepRapFirmware 3.2 planned improvements
Latest posts made by copystring
-
RE: 3D GCode Viewer integrated with DWC
Hey, this requires DWC 3.2-beta3 but there is no beta3 on github? Only beta2.
Compiling the source code of DWC results in "Plugin requires incompatible DWC version (need 3.2.0-beta3, got 3.2.0-beta3pre)" -
RE: RepRapFirmware 3.2 planned improvements
Please add inverted M80/M81 for meanwell PSUs.
I know. I'm inpatient. Is it a lot of work to implement this? -
RE: RepRapFirmware road map as at 15 February 2020
Any plans for M80/M81 support for meanwell PSUs?
I know I asked this before. Like many other. Is this anywhere on a plan? -
RE: RepRapFirmware 3.0 is released!
At one point there was a topic about 3.0 having the possibility to have M80/M81 inverted for those meanwell PSUs working exactly the opposite way of ATX PSUs.
This is not in this release or is it? Did not see it in the changelog. -
RE: Issues with G32
Yes. That is what it was.
I guess sometimes it helps when somebody else looks over it after being on it for too long
Thank you! -
Issues with G32
Hi.
Usually I try to solve issues myself however with this one I'm at a loss.
I have a Hypercube Evolution with a duet wifi and created my configuration with the configurator (https://configurator.reprapfirmware.org/).Now the issue I have.
When I home all axis and then enter G1Z0 in the gcode console the nozzle touches the bed just fine since I have configured the Y offset for the BL Touch just fine.
However, the moment I run G32 the nozzle does not touch the bed anymore after G1Z0. Instead it is way above the bed at about the distance between the bed and the created plane/mesh (this also seems to happen with G29).
I will attach my config below.Not sure what to do anymore. I have read the following topics about probing and followed the instructions and set the offset between the BL Touch and nozzle correctly (since it works before G32):
https://duet3d.dozuki.com/Wiki/Test_and_calibrate_the_Z_probe
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_BLTouchMy goal is to use two independent z motors to level the bed before every print.
For that I successfully used this guide: https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motors
12_1524933365731_tpre0.g 11_1524933365731_tpost0.g 10_1524933365731_tfree0.g 9_1524933365731_stop.g 8_1524933365731_sleep.g 7_1524933365731_resume.g 6_1524933365731_pause.g 5_1524933365731_homez.g 4_1524933365731_homey.g 3_1524933365731_homex.g 2_1524933365731_homeall.g 1_1524933365731_config.g 0_1524933365731_bed.g